BRAD MILLER
Member
- Mar 22, 2017
- 81
- 13
- Truck Year
- 2015
CAN ANYONE TELL ME THE EXACT AMOUNT OF TRANSMISSION FLUID TO ADD AFTER A FILTER/PAN REPLACE??????
-
Welcome to EcoDieselRam.com We see you haven't REGISTERED yet.
Your truck knowledge is missing!
- Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
- We have tons of knowledge here for your EcoDiesel truck!
- Post your own topics and reply to existing threads to help others out!
- We believe in quality OVER quantity, and a family friendly place for your #EcoDiesel home!
Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!
TRANSMISSION PAN/FILTER REPLACE
- Thread starter BRAD MILLER
- Start date
Marauderer
New Member
- Oct 6, 2018
- 27
- 8
- Truck Year
- 2015
If you didn't read BoostN's attachment it kinda goes like this.
Truck/Car level
start motor ensure trans fluid temp between 86*F and 122*F
rev motor to 2000 rpm to fill torque converter
Go to idle
run trans through all the gears for 10 sec each gear
Make sure temp between 86 - 122 If high turn off motor till temp is back in spec
With Engine running Remove oil fill plug
If fluid runs out let continue till it reduces to single drops.
If no fluid comes out then fill (while motor running) till fluid starts to come out
Reinstall fill plug
The End or "That's All Folks"
I plan on ensuring my temp is as close to 86*F as possible.
Truck/Car level
start motor ensure trans fluid temp between 86*F and 122*F
rev motor to 2000 rpm to fill torque converter
Go to idle
run trans through all the gears for 10 sec each gear
Make sure temp between 86 - 122 If high turn off motor till temp is back in spec
With Engine running Remove oil fill plug
If fluid runs out let continue till it reduces to single drops.
If no fluid comes out then fill (while motor running) till fluid starts to come out
Reinstall fill plug
The End or "That's All Folks"
I plan on ensuring my temp is as close to 86*F as possible.