Recent content by John Jensen

Don't know as I haven't used a full tank since the recall. Now I'm in Maui for a month so it will be a while

They do not flash Ecodiesels completing the Z46 recall

I am so glad you had no engine damage, could get it fixed, and returned home safely.

GDE does not pass CARB emissions. GDE cannot sell to Califunny truck owners.

Does what matter?

Ecodiesel vehicles built before June 2016 specs were changed in June 2016 to use 5w-40 oil and recommended Rotella T-6 or equivalent. Engine failures have nothing to do with brands of oil, only viscosity.

It will work on any Eco 2014-2018. Need AlpfaOBD or similar to program to correct Vin and Injector codes.

The best fossil fuel available has less lubricity than European fuel and the quality varies considerably in many areas. It has been attributed to the CP4 failures, thus the recommendations to use a lubricity-adding additive.

Alfa cannot do it, it requires a tune. Suggest an MRT tune from EOC

That's a great hitch but the pictured head is not a Sway Control head. You probably already know, when properly set up it should nearly lift the truck rear to its unloaded height. The bars should be parallel to the trailer frame. not angled down or up and the trailer should be level or down at...

Are you using a WDH? If you aren't, you should, if you are it probably isn't set properly

Yes, The CTS3 can tell you the DEF being used, the demand, its % Urea, etc. The CTS2 I believe only monitors the SCR temp (EGT4) I don't know what a "reductant quantity test" is The Edge website will tell you it can do

That's old school, before EPA and emissions systems/equipment. Many would add an ashless 2-stroke outboard motor oil for it's lubricity. Adding drained oil was probably doing the same thing but dirtier. Try it in today's close tolerance, high-pressure injected engines and I believe you'll...

Welcome to the forum The newest Edge CTS3 will do all that you mention except initiate a regen An Edge CTS2 will do it all and initiate a regen. I use a CTS2 on my 2016 1500 ECO's daily driver short-hop local trips. Whenever the CTS2 shows 65% soot level the Eco will regen. When it gets to 64%...

They just completed mine. Tubes and filter were also replaced. They do not flash the Ecodiesel ECU for the HPFP replacement, they only flash for the Cummins replacement.