-
Welcome to EcoDieselRam.com We see you haven't REGISTERED yet.
Your truck knowledge is missing!
- Registration is FREE , all we need is your birthday and email. (We don't share ANY data with ANYONE)
- We have tons of knowledge here for your EcoDiesel truck!
- Post your own topics and reply to existing threads to help others out!
- We believe in quality OVER quantity, and a family friendly place for your #EcoDiesel home!
Already registered, but need a PASSWORD RESET? CLICK HERE TO RESET YOUR PASSWORD!
ok3's latest activity
-
ok3 replied to the thread gen 3 banks intake install?.CPX in, stock muffler gone,replaced with 18"ss glasspack.. not too much drone or noise.. Now about as cleaned up as can be... -
ok3 replied to the thread Injection timing.If you are out of warranty, beore I bought a bosch pump ...I would sure ck out the cp"x" modified pump.. As uuual the gear heads have...
-
ok3 replied to the thread Second engine and still the same scenario.Your Better half is a keeper.. Sue would not- repeat would not- leave the driveway with any corners down! NOPE I am going to replace...
-
ok3 replied to the thread Sluggish throttle, died at stop sign..The banks and their throttle body are sure out of the park compard to that SWIRL VALVE abomination..an electric motor and sensors to do...
-
ok3 replied to the thread HPFP recall with GDE Afterlife tune.I would call GDE..
-
ok3 replied to the thread Second engine and still the same scenario.After a long look ... With 208Km on the clock.. I am thinking a detailed inspectionn of existing links... Then good bags, and an...
-
ok3 replied to the thread Second engine and still the same scenario.I am going to study the possibles..My 04 custom sway bar on that spring setup works pretty darn well, the extenderd frameand born free...
-
ok3 replied to the thread Second engine and still the same scenario.Yup the intercooler lines are a pain in the BUTT !I think it may take a ball joint setup to really locate the rear..Yes it feels really...
-
ok3 replied to the thread Second engine and still the same scenario.Only issue I have had is cold air side coming loose and going into limp mode...But I will say ipulled up a 7-8% 3000' grade @ 35 or so...
-
ok3 replied to the thread Second engine and still the same scenario.Congratulatioms you not only have guts....but you carry out what you start...Yup, the idiot's in the givamint...do not look at the...
-
ok3 replied to the thread Introduction.GREAT!!! Tow@60 thank you Since I blundered into my eco project....I was lucky to be in a no inspection state so had no concern...
-
ok3 replied to the thread Introduction.Had a stage 2 delete but left origional muffler on till now. Muffler had 207,000 miles on it.... I was concerned it was going to be an...
-
ok3 replied to the thread Second engine and still the same scenario.When I pulled the pan on the 8K mile gen 3...it was clean...The egr tube was covered in wipe off soot...The intake swirl valves were...
-
ok3 replied to the thread Second engine and still the same scenario.I now have "cleanedup" a gen 3. 8K mile engine.... Banks intake, 3" EOC exhaust clean from turbo to 3"glasspack..Eoc stage 2/tranny tune...
-
ok3 replied to the thread Second engine and still the same scenario.Did you find engine?