Recent content by SOP

BIGGTOMM - did you ever find the cause to your PO5ED code? I have the same one popping up and trying to figure out what my issue is.

GrearHead - thanks for the reply. I've been tied up with work the last several days and have yet to figure this out. I did reach out to GDE and they are always extremely helpful. They literally replied to me over the weekend of Thanksgiving and was not expecting a reply till early the...

I've got a P05ED code that keeps popping back up after I clear it. Anybody have experience with this? From what I have found online it's related to the DEF Heater line... Perhaps this is something that might be covered under the extended settlement warranty??

If it’s not the ECM or a dirty MAP then what are the other possible causes?

Update to my comment from Oct 5th. Truck is still at the dealer. They received a new ECM from Chrysler and it was also bad... Should have another one in today or tomorrow. I did go there last week and cleaned the MAP (took 5 mins in the parking lot) which was dirtier than I expected...

Thoughts on a GDE tune fixing it? Been waiting to do that and this makes me want to

My truck was doing the same thing, showing Service Electronic Throttle Control. I would reset the code (P0299) with my edge CTS2 and the truck would drive great. It was also showing codes P02E1, P02E0, and P02E8. Its at the dealer right now diagnosing the problem. They replaced the Throttle...

Has no one had these codes pop up? I cleaned the MAF yesterday, codes came back...

yes, sorry I sold them a long time ago.

I had a few codes pop up today. Check engine light came on immediately when I started my truck this morning and showed codes p02e8 & p02e1. After I drove for 10 miles I shut the truck off and cleared the codes. They came back in relative short order. I drove around for the afternoon, then...

I’m trying to figure out if my battery is due for replacement. I’ve got a 2014 so it’s over 4 years old. The dash reads 12v prior, and then 12v post startup for 10-15 seconds, then reads 13v. My Edge CTS 2 reads 13.8v once running for a minute . I tried to search around and couldn’t find if...

Yeah I was really happy about that.