Search results

That dealer was just wanting to sell fuel Filters. It's a waste to change at 8-10k and I think you know that as well. The injectors are fine, and it's low enough flow demand you'll probably never see the hpfp starving due to filter restriction.

Today's diesel lubricity is shit from what it was with sulfer. Little synthetic oil diluted into the fuel ain't going to hurt it, like op said it's a fine enough fuel filter. No different than running a synthetic petroleum additive for diesel lubricity. But it's otherwise waste, not like trying...

Yeah I do half of the time, I usually keep the old t6 2.5 jug so it's clean, and dump a gallon back into the fuel tank twice. It actually helped my cp4 as I had some cavitation noise before and not since I was doing that. I've got 201k.. and about 6300 hours for what it's worth. Also on a diet

Honestly a huge job, 12.5 hours of book time but 199,777 finally hit the first major failure I've experienced outside the tone wheel. Extremely intensive disassembly, transmission out, (refreshed the tone wheel) I did it in the garage in a few days. Patience and heat as you've got to remove the...

199 and change here. Pretty small repair list

Yeah they have recall out on the cp4.2 hpfp as does most every other diesel from various manufacturers that run a cp4. Honestly I expected it to be your tone wheel for crank position sensor, which comes around 90-115k, but accept the inconvenience and let them pay for it. Apparently you've had...

There is not a revision so it is the same part, unfortunately rather than throw away 1000$, run it until failure and get the reimbursement warranty.

It's a fake generated reading so disregard

Drive the piss out of it. That's how you keep it alive and healthy. Stop and go life isn't for it. Long highway commutes, Towing, hills, getting hot will keep it healthy. Knock on wood 195k I've put a vacuum pump and had the tone wheel failure which was recall reimbursement eventually.

The oil pressure displayed on your evic is just load and temp calculated. There's not an honest reading or sensor. I've not heard of a pan leaking but I'd check torque myself if there's a loose spot on what's likely a permadry gasket before committing to a reseal.

Yeah tiny little ones but she's noisy in the cab under power. Fine at speed but acceleration is a bit much for cab volume. Kinda echos in my Topper maybe?

Well I let the intrusive thoughts get the better of me yesterday! It's a little loud in the cab I might look for a small resonator to find a happy medium.

The high pressure fuel pump is on the front of the passenger cylinder Bank so pull your foam and get looking.

That's reasonable miles for a water pump. Not uncommon of any vehicle. Yes the OE pump is 700, obviously you found the aftermarket 100 one. The valve, a thermostat and 5 hours of labor. Welcome to vehicle ownership. I don't find your fault to be fca in this case.

So... 128k you had the tone wheel failure which is recalled so they pay for it?

191 now, I don't recall on the first time I did that one, probably 165

Well I've done the back 2, (firewall side) and thought another towards front burned out but it was #3 again. Learned with the second do it while engine is hot they pop right out. About 7 minute Repair no big deal.

Bad studs is about the only way this is possible and the grain is stretching. I'd get em replaced before you drop a wheel going down the road

Any more experience with these? I'm about to tick 184 and I'm finally getting some grief out of the ol girl. Few weeks back Hauling the Boat to the Lake went to pass and it threw the overboost and limped, last night went to drag a tree out of some flood ground and heavy boost really pissed er...

How many miles on your Truck? 95-115 is the general failure point. Dealer here I want to say pulls the starter and sneaks an endoscope in to view the tone wheel