yes and i can get it to run now but only if the temp sensor is unplugged i thought it was the coolant sensor so i changed it but thats not it .it seems like it shorting out or something i check the harness and grounds to ecm they all seem ok
just install a rebuilt engine and i cant seem to get it to run. It will turn over for about two seconds and try to run . I checked fuel rail pressure its about 8000 psi when cranking but only about 49 just when i turn the truck on. if i keep trying to crank truck over and hold gas peddle about...
mass air flow low circuit and turbo sensor low circuit i notice theres no ground strap at all to the engine or body or frame and it never came in running cause it through a rod so we put a rebuild in it and it wont start it tries to start for a second then shuts off like a security issue...
was wondering where grounds should be on block to frame i only see a ground from alternator bolt to battery i think thats why my truck wont start and throwing codes
just installed rebuild engine wont start. cranks over. runs for half a second then dies out changed cranksensor and tone ring when cranking shows me rail pressure around 8000 psi when cranking looks like immoblizer but it has no codes for it and red light is off