None that i know of, you can use additives to maintain but they never actually clean all of the soot out, you unfortinatly have to remove it and either clean it out or replace it and delete the emmisions systems to avoid it ever happening agan
I have a 2019 ED that recently hit 164,000km on the odometer and last week in ontraio it was pretty cold (-35c)
I started my truck to warm up every thing was fine until i got on the highway, then of courice the dreaded "service electronic throttle control" light came on and it wen into limp...
Well i can tell you the SLT has the plug by the hood latch but terminates under the fuse pannel that is under the hood, had to add a pin to plug A, pin 11 on the BCM and solder the resistor to the wire then grounded the resostor and it worked, so basically the SLT is not eqqupied but can be...
Well i fugured it out, and it works great, if any one is looking for the plug and the pin out for connector a pin 11 here it is, this plug is pocated at the top right corner of the BCM, simply put a wire and a female pin in the BCM plug and solder an inline resitor (1000ohm 1w 5amp) to the wire...
I did this to my truck last night but it appears that the hood latch sensor wire harnes is not pluged into the BCM i know this because it says remot start cancled hood open but i have the resistor in and every thing done right on alfa so now i need to figure out how to connet that harnes to the...
J
DIY Articles
Hood latch wireing harnes not conected at BCM
Thread starterJust-a-guy
Start date10 minutes ago
TagsNone
Unwatch
•••
J
Just-a-guy
New Member
10 minutes ago
Add bookmark
#1
Hey every one,
I have a 2019 ed 1500 slt
I have recently discovered how to enable remote start and...
Hey every one,
I have a 2019 ed 1500 slt
I have recently discovered how to enable remote start and ran into a bit of a snagg...
The hood latch wireing harnes dosn't seem to be connected to the body control module.
My question is has any one sucessfully connected it at the BCM?
If so what pin...