Search results

BIGGTOMM - did you ever find the cause to your PO5ED code? I have the same one popping up and trying to figure out what my issue is.

GrearHead - thanks for the reply. I've been tied up with work the last several days and have yet to figure this out. I did reach out to GDE and they are always extremely helpful. They literally replied to me over the weekend of Thanksgiving and was not expecting a reply till early the...

I've got a P05ED code that keeps popping back up after I clear it. Anybody have experience with this? From what I have found online it's related to the DEF Heater line... Perhaps this is something that might be covered under the extended settlement warranty??

If it’s not the ECM or a dirty MAP then what are the other possible causes?

Update to my comment from Oct 5th. Truck is still at the dealer. They received a new ECM from Chrysler and it was also bad... Should have another one in today or tomorrow. I did go there last week and cleaned the MAP (took 5 mins in the parking lot) which was dirtier than I expected...

Thoughts on a GDE tune fixing it? Been waiting to do that and this makes me want to

My truck was doing the same thing, showing Service Electronic Throttle Control. I would reset the code (P0299) with my edge CTS2 and the truck would drive great. It was also showing codes P02E1, P02E0, and P02E8. Its at the dealer right now diagnosing the problem. They replaced the Throttle...

Has no one had these codes pop up? I cleaned the MAF yesterday, codes came back...

yes, sorry I sold them a long time ago.

I had a few codes pop up today. Check engine light came on immediately when I started my truck this morning and showed codes p02e8 & p02e1. After I drove for 10 miles I shut the truck off and cleared the codes. They came back in relative short order. I drove around for the afternoon, then...

I’m trying to figure out if my battery is due for replacement. I’ve got a 2014 so it’s over 4 years old. The dash reads 12v prior, and then 12v post startup for 10-15 seconds, then reads 13v. My Edge CTS 2 reads 13.8v once running for a minute . I tried to search around and couldn’t find if...

Yeah I was really happy about that.

So I got my truck in last week for the diagnostic to figure out the leak. The dealer said the water pump needs to be replaced along with a tube that was also leaking. Both very minor leaks. The water pump is on backorder so they are going to contact me once they have that and the other...

My coolant is down about an inch in the overflow tank on my 14'. Calling the dealer tomorrow to set up a time to take it in. Any idea what is all involved with replacing the water pump? I have a stream of coolant down the lower crank cover and onto the crossmember. Do they also replace the...

I pulled the cover. It's just lined with a thick dense foam which must be for sound. I trimmed the bottom a little where it was flaking and put it back on. The top of the cover however had dried coolant on it. Wasn't really fresh coolant, but there was definitely a leak at some point, or a...

I'm thinking it's got to be something with the intake somewhere because it goes away when coasting and comes back with just a lil throttle. I don't know that it's something wrong with the turbo, but more likely a leak somewhere? I feel like if it was the actual turbo it would still make noise...

Yes. I'm going to pull that cover off and see. Not sure why it's doing that... Is the foam in there as a sound deadener or does it serve another purpose?

thanks. still trying to figure it out. It's really consistent, typically can hear it up around 70 mph, at which point I think the road noise ect drown it out. I know the squeak Pizza04 is talking about regarding the fan blower motor, and this is definitely not that.

hey guys - I’ve got a squeak / crickets sounding noise that appears to be coming from the driver front. I was hunting around under my truck tonight trying to diagnose the issue and found a couple of things that don’t seem right. Where the belt goes behind the black cover on the lower part of...