Search results

Ok, I metered the plugs... #1 plug was .221v and plug #4 read 124.3 mv... I put new glow plug in and grounded it... it lit up.. I put the old old in the plug and grounded... did not lite!! I see there are several different part numbers for the same looking plug..The one I used first was only $21...

Negative.. it said plug 4... front drivers side... I did check it with Ohm Meter,, was at .4.. which new one read .2 I dont think it was even bad..

This vehicle is so hard to find information on.. No wiring diagrams.etc.... Unless you spend big $$ for the service book on dvd

No other codes... When I clear them, It may go a day or so... then back on

Hello, I have an issue I cant figure out.. Started with GP#4 CEL, replaced it.. good for a couple weeks.. CEL back on for same plus P06BC... Ordered and replaced the controller.. Fixed... for 2 days.. CEL back on for all the same.... Anyone else have this issue and if so what was the fix?? Thank You

CEL on and replaced with new... no luck still do not work CEL on..

Anyone have any luck with removing active grill shutters from ecu using Alfaodb?

Any one have the wiring schematic for a 14??

Hello. I have a 14 eco which started giving me the U0284 Code. I installed new shutter assembly and still does the same thing.. on start up the motor opens and does not complete the calibration. I checked and cleaned the plugs located on the frame as I seen as a possible cause. Next thought is...