New profile posts

Engine fails me again. No errors just got in, turned the key and just gave then slow groan of "you left something on" kind of last breath. So I charged the battery, all dash light on but will not turn over.

I am new to the group. I have a 2020, leaking fuel out of one of the wire connectors on top of fuel filter. I would appear I will have to order a new filter body. Are there any aftermarket parts out there? Also what is the procedure for releasing the fuel line clips and wire harness clips, no doubt it is easy if you know how they work. Thanks for any input

I stumbled on to this site still don't know why it's here? I'm looking for information on Diesel particulate filter issues

What is the measured voltage on pin 11? Is this right at the connector? The code description states it can be from a high or low voltage. Does the engine start and run? As there is another pin that sends power to the auto stop relay. Only other thing I can think of would be the CAN bus circuit. With luck this info is to late and you have already gotten it fixed.
Wayne

Bought my Laramie 2016 with 96698k's now has 162556k's paid 4 months ago wanting to sell.

hey so how did you fix your P0428 error? was it the temp sensor? or O2 sensor?
I am having the exact same issue. parked regen stops due to catalyst temp sesor reading too high. runs steady around 600c then instanly bolts to 999 and stops regen

2017 1500 Laramie 4x4, need part number for the passenger side stub shaft seal; and has anyone done this repair themselves?

Thanks

20160 Ram Laramie 4x4 EcoDiesel @ 100K stock. Just got HPFP recall in the mail. Replaced the water pump @ 98K. Otherwise 'No Problems' here in ATL.

Coolant smell from engine with no visible signs of leakage? Has anyone experienced a failure with this?

2018 Ram Ecodiesel 54,000 miles, engine blew up. Ram put in new engine gave 2 year warranty. 3.5 years and 73,000 more miles. The truck shut down, no notice, Low Oil Pressure. I checked the oil it was fine. I started the truck up, drove 1 mile, it quit again, said Electronic Throttle Control.

Did you find a solution for the P1083 error? my truck is acting the same way.

Replaced intake manifold on my 2015 eco diesel and can't find a torque value or pattern. does anyone have any ideas?

I'm new here, I have a 2017 eco diesel with 91k on it. I ran it out of fuel and after putting 2 gallons in followed online instruction to prime and start. I got it to start, but dies anywhere from 10 seconds to 2.5 minutes and then have to reprime and start again. Could the fuel filter be overwhelmed since I ran out of fuel or possibly the injector pump or fuel pump failing? Waiting for a tow truck now. Ugh!

2016 dodge ram laramie ecodiesel 3.0 throttle body problems

Are you still looking for one?

Jimmy wooldridge

2014 Ram ecodiesel 220k kms. In southern Ontario, Canada. Ok on maintenance issues but have been reading a lot about stage 1 and 2 and full deletes. All is foreign to me mechanically challenged. I would need to take it to someone to do it. Main question is , Is it legal and anyone in Southern Ontario know where to get it done and approximate costs. TIA.

Should a 2015 eco diesel rev to only 3000 rpm in neutral

Battery dies after truck has been shut off

Need help on what to disable in HPTuners once the stock pcm has been read, what parameters in the exam table’s specifically for a 2018 Ram EcoDiesel